Molecular Formula | C25H28O3 |
Molar Mass | 376.5 |
Density | 1.0493 (rough estimate) |
Melting Point | 191-198°C(lit.) |
Boling Point | 465.03°C (rough estimate) |
Specific Rotation(α) | D25 +58 to +63° (c = 2 in dioxane) |
Flash Point | 212°C |
Water Solubility | 0.4mg/L(25 ºC) |
Solubility | Practically insoluble in water, freely soluble in methylene chloride, sparingly soluble in acetone, slightly soluble in methanol. |
Vapor Presure | 4.08E-12mmHg at 25°C |
Appearance | neat |
Color | White |
Merck | 3703 |
BRN | 3107526 |
pKa | 15.06±0.40(Predicted) |
Storage Condition | 2-8°C |
Refractive Index | 1.5460 (estimate) |
MDL | MFCD00003692 |
Physical and Chemical Properties | White or yellowish crystalline powder. Odorless. Tasteless. Stable in air. Melting point 191-196 °c. Right optical rotation. Soluble in ethanol, acetone, dioxane, etc., slightly soluble in vegetable oil, insoluble in ether, almost insoluble in water. |
Use | Can promote the growth and development of female reproductive organs. |
In vitro study | Estradiol benzoate is a synthetic ester, specifically 3-benzoyl Ester, a natural estrogen, Estradiol. Estrogens guide the development of female genes during embryonic development and puberty. Estradiol is the main female hormone secreted by the ovaries before menopause. Estradiol benzoate is an Estradiol analog that contains a benzyl ester in the C- 3 position and is often used in combination with progesterone to induce estrus in domestic animals. The compound binds to human and murine estrogen receptor α (ERα), as well as to chicken erbium with IC50 values in the range of 22-28 nM. This reflects a 6-10 fold reduction in affinity compared to estradiol. |
Hazard Symbols | T - Toxic |
Risk Codes | R60 - May impair fertility R61 - May cause harm to the unborn child R40 - Limited evidence of a carcinogenic effect |
Safety Description | S53 - Avoid exposure - obtain special instructions before use. S22 - Do not breathe dust. S36/37/39 - Wear suitable protective clothing, gloves and eye/face protection. S45 - In case of accident or if you feel unwell, seek medical advice immediately (show the label whenever possible.) |
WGK Germany | 3 |
RTECS | KG4050000 |
FLUKA BRAND F CODES | 8 |
HS Code | 29372319 |
Reference Show more | 1. Fan Zhao, Cao Liming, Liu Qing, et al. Effect of Wenzhong Chushi Quyi decoction on dairy cow placenta retention in cold region in winter [J]. Heilongjiang Journal of Animal Husbandry and Veterinary Medicine, 2020, No.598(10):122-126 160. 2. Luo Wenjing, Liang yuan, Zhou Zhiming, et al. Determination of 20 female hormones in health foods by high performance liquid chromatography-tandem mass spectrometry [J]. Stoichiometry for chemical analysis, 2019(3). |
This product is 3-hydroxyestrane-1, 3,5 (10)-triene-17 tablets of alcohol -3-benzoate, calculated as dry product, the content of C25H2803 shall be 97.0% ~ 103.0%.
The melting point of this product (General 0612) is 191 ~ l96 °C.
take this product, precision weighing, and two oxygen six ring dissolved and quantitative dilution made of each lml containing 10 mg of the solution, according to the law (General 0621), the specific rotation was 58 ° to 63 °.
take this product, precision weighing, plus absolute ethanol dissolution and quantitative dilution of 10ug per lml solution, according to UV-visible spectrophotometry (General 0401), the absorbance was measured at a wavelength of 230nm, and the absorption coefficient was 490 to 520.
take this product, add acetonitrile to dissolve and dilute to make a solution containing 2mg per 1ml as a test solution; Take 1ml for precision measurement and put it in a 100ml measuring flask, as a control solution, it was diluted to the scale with acetonitrile and shaken. According to the high performance liquid chromatography (General 0512) test, with eighteen alkyl silane bonded silica gel as filler, acetonitrile-water (60:40) as mobile phase A, acetonitrile as mobile Phase B, the linear gradient elution was performed according to the following procedure, and the flow rate was adjusted so that the retention time of the Estradiol benzoate peak was approximately 26 minutes and the detection wavelength was 230mn. The number of theoretical plates shall not be less than 4500 calculated by the peak of Estradiol benzoate, and the separation degree between the peak of Estradiol benzoate and the adjacent impurity peaks shall meet the requirements. l0ul of the test solution and the control solution were respectively injected into the liquid chromatograph, and the chromatograms were recorded. If there are impurity peaks in the chromatogram of the test solution, the area of a single impurity peak shall not be greater than the area of the main peak of the control solution (1.0%), and the sum of each impurity peak area shall not be greater than 1.5 times (1.5%) of the area of the main peak of the control solution.. The chromatogram of the test solution is 0.01 times smaller than the main peak area of the control solution.
The wood was dried to constant weight at 105°C, and the weight loss should not exceed 0.5% (General rule 0831).
This product is a sterile oil solution of Estradiol benzoate. Estradiol urinates (C25H2803) shall be present at 90.0% to 110.0% of the labeled amount.
This product is a light yellow clear oily liquid.
take an appropriate amount of this product (about 2mg equivalent to Estradiol benzoate) with an internal volume pipette, put it in a 100ml measuring flask, add an appropriate amount of anhydrous ethanol, fully shake, and after the solution is clarified, dilute to the scale with absolute ethanol, shake, as a test solution, according to the chromatographic conditions under the item of Estradiol benzoate content determination, take 20u1 injection of human liquid chromatograph with precision, record the chromatogram; in addition, an appropriate amount of Estradiol benzoate reference substance was accurately weighed, dissolved and quantitatively diluted with absolute ethanol to make a solution containing about 20ug per 1 ml, and the same method was used for determination. According to the external standard method to calculate the peak area, that is.
with Estradiol benzoate.
(l ) lml:lmg (2)lml:2mg (3)lml:5mg
light shielding, closed storage.
light shielding, sealed storage.
measured by high performance liquid chromatography (General 0512).
silica gel bonded with eighteen alkyl silane was used as a filler; Methanol-water (80:20) was used as a mobile phase; The detection wavelength was 230mn. The number of theoretical plates is not less than 4500 calculated from the peak of Estradiol benzoate.
take about 25mg of this product, precision weighing, put it in 25ml measuring flask, add methanol to dissolve, cool, dilute to the scale with methanol, shake, take 5ml precision, place in 25ml measuring flask, dilute to the scale with methanol, shake well, as a test solution, take 10u1 injection of human liquid chromatography with precision, record the chromatogram; Take Estradiol benzoate reference substance, and determine with the same method. According to the external standard method to calculate the peak area, that is.